Refer to the SCADASuite Reference Manual for detailed information. This Applications Manual is meant to be used alongside the reference manual.
The video below shows how to add enable gas lift for the well in the Plunger Lift - One Well configuration.
The application's configuration is modified so that gas is injected before the plunger arrives (pre-arrival injection) and after the plunger arrives (post-arrival injection). The Gas Lift Control Mode is set to Plunger so that gas injection can be coordinated with the plunger cycle. Simulation is used to provide a maximum gas injection rate when the injection valve is fully opened. By setting an injection rate below this value, the injection valve PID can control the valve to a reasonable value.
The Plunger Lift configurations used in this demo can be downloaded here.
Simulation should be used with caution. When simulation is enabled accidentally, real values in Modbus registers could be overwritten, leading to undesirable operation.
